Advanced Motion Controls Announces Analog Servo Drives

Published: June 10, 2013

CAMARILLO, CA | Advanced Motion Controls is offering the new B060A400AC and B100A400AC analog brushless servo drives providing up to 21kW and 35kW, respectively. 

The B060A400AC is capable of outputting 60A peak and 30A continuous while the B100A400AC outputs 100A peak and 50A continuous. These servo drives can operate with both AC and DC supply voltages with an AC voltage range of 200-240VAC and a DC voltage range of 255-373 VDC. The built-in shunt circuit alleviates regeneration issues to increase the maximum deceleration rate of large inertial loads. Modes of operation include Current, Duty Cycle, Voltage, IR Comp, Encoder Velocity, Hall Velocity, and Tachometer.

Company says DIP Switch selectable settings allow fine-tuning to match motor and machine dynamics without having to change components on the board. Included are 17 current loop integrator gain settings, 32 current loop proportional gain settings, 8 velocity loop integrator gain settings, and 4 tachometer scaling settings. In addition, selectable inhibit logic, fault logic, and linear ramping are reported to make these drives compatible with more controllers.

This email address is being protected from spambots. You need JavaScript enabled to view it.